Everglue Activator Spray — Curing Accelerator for Super Glue, 200 ml

Everglue Activator Spray — Curing Accelerator for Super Glue, 200 ml

Everglue Activator Spray is a reliable curing accelerator formulated for cyanoacrylate adhesives. This 200 ml aerosol provides a controlled, even spray to trigger near-instant polymerization of super glue, dramatically reducing tack time and speeding up workflows. Use to fix parts in position immediately, improve bonding on porous or hard-to-wet surfaces, and minimize squeeze-out or repositioning time. Suitable for small repairs, model making, fixtures and many industrial applications where rapid handling strength is required.

Key benefits

• Instant cure acceleration — parts reach handling strength within seconds
• Precise, clean application via aerosol spray
• Improves adhesion on porous or difficult surfaces
• Reduces repositioning time and glue run/overflow
• Convenient 200 ml size for workshop and on-site use

Technical data

• Net content: 200 ml (aerosol)
• Active for cyanoacrylate adhesives
• Recommended operating temperature: +5 °C to +35 °C
• Store: cool, dry, away from direct sunlight and heat sources

How to use

1. Clean and, if needed, lightly abrade bonding surfaces.
2. Apply a small amount of super glue to one surface.
3. From ~10–20 cm, spray the activator briefly onto the opposite surface or directly above the glue.
4. Press parts together; handling strength is typically achieved within seconds.
5. Remove excess adhesive and activator after cure.

 

Notes

Everglue Activator Spray — Curing Accelerator for Super Glue, 200 ml
 

Safety & storage

• Keep out of reach of children.
• Use in well-ventilated areas; do not inhale spray.
• Avoid contact with skin and eyes. In case of eye contact, rinse immediately with water and seek medical advice.
• Highly flammable — keep away from heat, sparks and open flames.
• Do not puncture or incinerate container; dispose of according to local regulations.

Artikelnummer: 650006

• EAN/GTIN: 4260256384255

Unique Formula Identifier

• • UFI: HEJ8-AXPC-9E9Q-6EJ2

Gefahr

 

Gefahrenhinweise

• • H222 Extrem entzündbares Aerosol.
  • H229 Behälter steht unter Druck: Kann bei Erwärmung bersten.
  • H319 Verursacht schwere Augenreizung.
  • H336 Kann Schläfrigkeit und Benommenheit verursachen.

Sicherheitshinweise

• • P101 Ist ärztlicher Rat erforderlich, Verpackung oder Kennzeichnungsetikett bereithalten.
  • P102 Darf nicht in die Hände von Kindern gelangen.
  • P210 Von Hitze, heißen Oberflächen, Funken, offenen Flammen und anderen Zündquellen fernhalten. Nicht rauchen.
  • P211 Nicht gegen offene Flamme oder andere Zündquelle sprühen.
  • P251 Nicht durchstechen oder verbrennen, auch nicht nach Gebrauch.
  • P410+P412 Vor Sonnenbestrahlung schützen. Nicht Temperaturen über 50 °C/122 °F aussetzen.

Besondere Kennzeichnung

• • EUH066 Wiederholter Kontakt kann zu spröder oder rissiger Haut führen.

Gefahrbestimmende Komponenten zur Etikettierung

• • Enthält: Aceton; Propan-2-on; Propanon.